Hydraulic pumps online shopping with UnwinHydraulic 2021? Now split your log into pieces in no time with this 16 GPM hydraulic pump from Tooltuff Direct. This 2-stage replacement power unit works on most of the log splitters available on the market. Double Performance With The 2-Stage Hydraulic Pump: This 2-stage pump provides more rapid cycle times, more possible pressure even with the small engine, and improves overall performance at a great extent. It is an incredible option for using on log splitters. Its efficiency can be as much as 85%. So get the best out of your job with this best power unit. Standard Technical Specifications: This brand new Hydraulic Log Splitter works at 16 GPM and 3600RPM. It covers all the standard specifications for other components as well including the model, inlet-outlet port, overall dimension, etc. The gas engine is 8HP or larger. It solely supports the direct drive while the horizontal shaft is used only for the open center systems. Stage wise GPM and PSI as follows: 13 GPM at 650 PSI at the first stage, and 3.5 GPM at 2500 PSI at the second stage. Max supported pressure is 4000 PSI.
The four most common modes of failure in piston pumps result from oil contamination, fatigue that results from transient pressure spikes, blocked or restricted pump inlet, and pump case over pressurization. These four modes account for the vast majority of all failures seen in the thousands of units inspected and repaired each year by the service technicians working at Motion Industries. Contamination can be the result of many things, including egress of water, environmental contaminants or component ware elements. Telltale signs of contamination include valve plate scoring, vertical scratches on piston barrels, scratches on the face of pistons, excessive wear of saddle bearings (or embedded particulate), plugged orifices, stuck compensator spools and pistons being seized within the cylinder bore of the barrel.
There are a few factors you should consider while choosing the right hydraulic pump. First of which is the viscosity. The viscosity refers to the resistance of flow. High viscosity hydraulic pump is not recommended as the liquid should freely flow. Choosing a weak pump can lead to a higher viscosity which will make the pump overwork and reduce its lifespan. Other specifications should be checked regarding its motor, shaft, function valves, oil tank, and other components whether they meet the required benchmark. If there is still any confusion you can feel free to ask us about the hydraulic pumps and its specifications to get yourself clarified whether it meets your needs or not. See even more details at hydraulic testers.
Spinning the gears without an uninterrupted oil supply will result in metal-to-metal contact between critical parts in the pump, which are designed to run on a hydrodynamic film of oil. This loss-of-lubrication damage may not be apparent once the pump fills with, and starts displacing, oil but by then the damage is done. So the prudent thing to do is to assume all “self-priming” hydraulic pumps actually are not (especially during initial start-up). If possible, always purge the intake line of air. If appropriate, consider turning the pump by hand (gear-type only) with the outlet vented to ensure it isn’t air bound. And if safe to do so, bleed the outlet on start-up to ensure the pump is displacing oil (and not spinning in an air-lock).
We are one of the UK’s largest stockists of high quality hydraulic components including cast iron gear pumps, A10V axial piston pumps, motors and spares. We are currently holding over £1 million pounds worth of stock for our loyal customers. Products include Parker/Commercial/Ultra, David Brown/Hamworthy, ASA Hydraulik, Rexroth/Bosch, Hydac, Vickers/Eaton/Charlynn, Sun Hydraulics, Stuaff, Denison, Oilgear Towler, SAI, Danfoss , Schroeder, LHA, Europower, Webster & Webtec Test Equipment, Holmbury/Stucchi couplings. Find even more details at this website.